Message-ID: 
Newsgroups: AIRGUN.LIST
> 
>  Phil, I agree, but before I give up, do this.... Take a piece of paper,
> draw a rotation on it, then look at the back of the paper! reversed!    
I
> get this from motor rotations, if it's cw facing shaft end, it's ccw
facing
> lead end..... on some non reversible motors, it's necessary to remove the
> shaft/rotor, and reverse it.... Mike What I'm saying is from breech end
to
> muzzle ona RHT barrel the pellet turns right.... flip the ends, and
pellet
> rotates left? correct? Mike
> 
Wrong!  If we stand facing each other and we both draw a clockwise circle,
they will appear to be opposite each other . So that means one of the
clocks is going counter-clockwise ?   Enough already. 
 I finished my 5 inch telephone dial for the side wheel Leupold. The 50
foot adapter is mounted in the Butler Creek flip up. The Luepold is sittng
in a set of  Sportsmatch mounts on the repaired Cr-94. The weather man in
PA promise's improving weather  the next few days.(They're never wrong -
are they?) Stay tuned.  
 The repair job on the trigger of the CR-94 consisted mainly in replacing
the spring. Not the one under the trigger itself. The new one is stiffer
and it is now possible to set the trigger properly.  At least I can load a
pellet and close the bolt and the gun doesn't go off until I squeeze the
trigger.
 
 Phil.P.
--- QScan/PCB v1.19b / 01-0671
---------------