Hi..
 >  CH> Basicly, you need a thing called an eprom programmer. I built mine 
from
 >  CH> a kit published by an australian electronics magazine  and sold by a 
Do
 > you have a schematic? I'd like to build one.
Try to find the magazine - Electronics Australia - unsure which edition it 
was in exactly - about 1994 I think... Most hobbiest electonics magazines 
have published at least one eprom programmer design over the years, so try 
your local library perhaps?
 >  CH> Could we move this discussion to tech or dr_debug?  It's drifting
 >  CH> off topic.
 > sorry.. I don't thing this bbs has those areas..
OK.. but let's keep it short - or take it to netmail, which your BBS must 
carry, by Fidonet rules.
 I'm currently writing a program for examining the 
Plug and Play features found on modern motherboards - PnP BIOS, ESCD, DMI, 
DPMS, etc... have you (or any lurkers reading this) any experience in this 
area? I'm especially looking for the EISA specifications, as these are the 
key to PnP... it would seem that the only place to find them, however, is on 
Compuserve PlugPlay forum, which I don't have access to.
    Craig
--- FMail/386 1.20+
---------------