Re: All nodes with (E) status
  By: Nightfox to All on Tue Jun 14 2022 10:31 am

 > I've been running GTKMonitor since I moved my BBS to Linux, and this morning
 > I noticed GTKMonitor was showing (E) next to all my nodes.  The wiki says
 > that means the node will run its daily event (if one is specified) before
 > waiting for another call:
 > http://wiki.synchro.net/ref:node_status
 >
 > The thing is, I don't have any daily event commands specified for any of my
 > nodes.

That's correct, the 'E' status is set without regard to whether or not any daily events are actually configured for a specific node.

 > I'm wondering what might cause all the nodes to go into the E
 > status?

It happens ever night. But the flag is auto-cleared too by sbbs.

 > I closed and re-started sbbs and then none of my nodes were showing (E)
 > status anymore.

Normally, they'll get cleared automatically when the node is connected to by a client (or when an already connected client disconnects). I think what you're describing is normal behavior.
-- 
                                            digital man (rob)

Synchronet/BBS Terminology Definition #37:
FTSC = FidoNet Technical Standards Committee
Norco, CA WX: 77.8øF, 53.0% humidity, 7 mph E wind, 0.00 inches rain/24hrs
--- SBBSecho 3.15-Linux