MR> MR>and it won't even loosen a screw. What's the point? I'm going to use it
MR> MR>with a pin chuck to make tiny holes since it turns about 300 rpm.

MR> JE> I thought the "chuck" was the part into which one inserted
MR> JE> bits, (pin) etc. NOT the bit (pin). VBG

MR>A "PIN CHUCK" is a smaller chuck with a 1/4" shank
which fits into a
MR>typical 1/2" or 3/8" chuck as an adaptor for bits smaller than about
MR>1/16". A pin chuck could be used to drill circuit board holes for
MR>resistors, transistors, IC's, etc.

The standard chucks on my 1/4" drills will handle bits even
smaller than 1/16".

Jay
---
 þ OLXWin 1.00b þ Poop deck: The bottom of a bird's cage.