Hello Mark,
Replying to a message of Mark Corona to John Meroth:
 MC> In a message of 20 Jul 95  16:56:06, John Meroth wrote:
 JM>> The receiver converts the signal to a voltage. 2.5vt is usually the
 JM>> center position. as you move the stick and change the signal, the
 JM>> reciver follows the pulse and shifts the voltage either up or down. 
 JM>> It's been a long time since I worked with those circuits and I hope
 JM>> I explained it clearly enough for you.
 MC>    It's been so long that they don't work that way anymore.  %^)  The
 MC> signal changes pulse width, not voltage.
 Hum, time to dig the books out, again. All the servos I have work this way 
and some of those are less than a year old.
 Capt. Diesel
--- FleetStreet 1.04 NR
---------------