Hi Rich Wonneberger, Yes it's me again 
19-May-96 18:46:03, Rich Wonneberger wrote to All
          Subject: 4.1 under OS/2
 RW> Got a strange problem installing 4.1 under Warp..  I cant get the
 RW> AHA1540.DSK
 RW> driver to load..  The address is right, 330.. I check'd in the util at
 RW> bootup
 RW> anyway..
 RW> The client stuff went ok, ex for the network error when I boot..  I
 RW> figured if
 RW> there's no server that would cause it??
 RW> The server seems to start, I just cant see the drive..  :{
 RW> The drive btw is a Conner 2 gig SCSI, with boot magager install'd, a 200
 RW> meg
 RW> FAT partition for OS2, about 1.5 gig HPFS for Warp, & I was gona use the
 RW> rest
 RW> for Novell..
 RW> The message I get is:
 RW> Unable to reserve hardware, possible conflict
 RW> Module init failed
 RW> Module not loaded
 RW> I thought I had it install'd once sharing the controller with Warp, but
 RW> am not
 RW> sure if I had IDE in the machine or not..  Had several test machines I
 RW> was
 RW> trying OS/2 on befor setting up this new machine for this & running my
 RW> board..
 RW> Any ideas??
 RW> TIA
 RW> Rich
 RW> I-Net    turtil@chester.ny.frontiercomm.net
I am running 4.1 under Warp conncet right now.
First DO NOT load the Adaptec driver during the 4.1 install. It should
automaticaly load the diskshare driver, this is all you need.
If you plan on sharing the NIC between the server & the client you must
install the client first.
If you wish to run the server & do Peer to Peer or TCP/IP between OS/2
machines I recomend you get a second NIC for the server. Use the 1st card
for the client & server. User the second for Peer-to-Peer & TCP/IP.
If you have any more questions feel free to ask.
William H. Geiger III
Geiger Consulting
whgiii@amaranth.com
--- Terminate 4.00/Pro
---------------