Alexander Bilan wrote in a message to Roy J. Tellason:
> I just wish that there was some easy way to get the correct dimensions. 
> I could pull one of the bolts out,  but I'm not crazy about what I'll find
> there when I do.
 AB> Got any car shows/meets happening in the area still? 
Not that I'm aware of offhand.  The last one I heard about was around the 
beginning of the month,  and at that point in time I had just started working 
and didn't have any funds for the show,  much less any parts I might want to 
buy...
 AB> Pay a visit with your tape measure, get permission, and crawl 
 AB> under the car and measure. =)  Or the auto wreckers again, and 
 AB> measure each corner on a vehicle with decent looking bushings.  
 AB> Then, cut some urethane to fit.
If I find some decent bushings at a junkyard,  I'll probably buy 'em!  The 
thing is,  I'd have to find a vehicle where they'd been replaced,  as most of 
what's going to be out there in the yards is going to be in as bad a shape as 
what I've got in there now.
I'm still exploring some options,  hoping I can get this fixed before the 
really nasty weather gets here...
email: roy.j.tellason%tanstaaf@frackit.com 
--- 
---------------