Hello g00r00!

Thank you for your message!

On 13 Jul 2022, g00r00 said the following...
 g0>  BW> published, and I'll be happy to test all the password reset/e-mail
 g0>  BW> validation stuff again!)
 g0> 
 g0> There should be a new build up now for you to try!

Thanks! The logic for sending hackwarn messages seems to be working just fine now! I think I tried all possible combinations of yes/no, correct/incorrect
answers and hanging up at different points. :)

It also finds pwreset.ini and emailval.ini correctly now.

However, it appears to send the entire file instead of only the text in the [Text] stanza. (I have textmci = true if that would make any difference.) Same thing for both pwreset.ini and emailval.ini.

So the e-mail text looks like a copy of the .ini file but with MCI codes replaced everywhere, also in the comments. :-D

Example (e-mail text resulting from pwreset.ini):

;
; IRFXYQDP will be replaced in the [Text] section with the code required
; for password reset.  Traditional MCI codes are available for from and
; subject lines but not in Text unless enabled by setting textmci to true

[General]
        from_name       = Star Collision BBS
        from_addr       = scbbs-no-reply@xyz.com
        subject         = Password reset code for Star Collision BBS
        textmci         = true

[Text]
This is an automated message from Star Collision BBS.

Please enter the following code when prompted by the BBS
to reset your password:

IRFXYQDP

IMPORTANT NOTE: This e-mail was sent from an UNMONITORED e-mail address
and SHOULD NOT BE REPLIED TO. If you need to contact the SysOp, please
send an e-mail to scbbs-sysop@xyz.com instead!


Hoping that you can take a look at that when you have time.

Thanks in advance! =)

Best regards
Bj”rn

--- Mystic BBS v1.12 A48 2022/07/13 (Linux/64)