>Where is a good point to tap the circuit of a PRO-2026 to make a
 >dedicated tape recorder output?  Thanks!
I'm not familiar with the cicuitry of the '2026, but this pretty much applies 
to ANY radio. Find the place on the board where the speaker wires are 
connected. The transistors and/or IC chip nearest to that point is most 
likely the audio amplifier. If you have some type of "outboard" audio amp 
(like a stereo system) you should be able to probe around the area and find a 
spot that works well. This spot will somewhere between the receiver output 
and the audio amp.
--- SLMAIL v5.02  (#0226)
---------------