On 13/06/18 12:48, R.Wieser wrote:
> mm0fmf,
>
>>> If that meter is registering 0v between 5v and a GPIO pin, then that
>>> implies/both/  leads are at 5v,
>>
>> Really?
>
> Yes, really.
>
>> When my meter leads are unconnected the meter registers 0V. Does that
>> imply both leads are also at 5V?
>
> I think your logic chip has broken.  Did you put 5v on 3.3v inputs perhaps ?
> :-)
>
> Regards,
> Rudy Wieser
>
>

Ok I have received the new infra red wide angle camera, connected it up
and got the PiZero fired up, did this: raspistill -k, and the camera
took my picture.
So after all that , it turned out to be the crappy £5 ebay camera which
was at fault, and not the sensor as it works fine now.

--- SoupGate-Win32 v1.05