On 12/06/18 11:17, Mark J wrote:
> In message 
>            mm0fmf  wrote:
>
> [snip]
>
>>>>>
>>>>>      Uhm... 0v between "motion pin" and 5v pin means the "motion pin"
>>>>> is at
>>>>> 5v also...
>>>>>
>>>>>      BUT! RPi GPIOs are 3.3V inputs...
>>>>>
http://www.mosaic-industries.com/embedded-systems/microcontroller-projects
>>>>>
/raspberry-pi/gpio-pin-electrical-specifications#rpi-gpio-input-voltage-an
>>>>> d-output-current-limitations
>>>>>
>>>>>
>>>>> A 5V signal on that "motion pin" could easily result in burning out
>>>>> the RPi
>>>>> GPIO (if you are lucky, only the one GPIO will be killed)
>>>>> http://www.notenoughtech.com/raspberry-pi/rpi-gpio/
>>>>>
>
> [snip]
>
> The use of even a high impedance voltmeter between 5v and 3.3v GPIO pins
> worries me - maybe this has already been covered, but...
>
> If that meter is registering 0v between 5v and a GPIO pin, then that
> implies /both/ leads are at 5v, so the 3.3v pin has 5v on it, all relative
> to 0v. Can the use of a voltmeter in this way kill an IO? My feeling is
> that a voltmeter should always be used from 0v to 5v or 3.3v, to avoid
> this issue. Maybe I'm wrong...
>

The said camera was a cheapo ebay one, and I've ordered this from
Pimoroni: Camera Module for Raspberry Pi Zero - Wide Angle.

As the saying goes, you only get what you pay for.

--- SoupGate-Win32 v1.05