On Fri, 08 Jun 2018 16:09:42 +0100, RobH wrote:

> I have put together a motion sensor with a camera on a PiZero. I got it
> working fine for a the first few days, then it just stopped working. I
> then ordered a new motion sensor, but the problem still remains.
>
> I ran this raspstill -k to check the sensor and camera were working, but
> they are not, and told to check the camera cable.
>
> I have un plugged the camera cable at both ends, then re seated them,
> and made sure they were fully in the socket before I pushed back the
> clip. There is no change at all, so what else could it be.
> I have unplugged the jumper wires from the PiZero, and reconnected them,
> but still no change

FWIW - some time back on one of my rpi2B's, the camera stopped working. I
later realized that it happened after an 'rpi-update', which I used to do
regularly. I downloaded a new raspbian image and put it on another sd
card - presto, the camera worked again.

Suggest you do a clean install to a new card and see if that solves it.

--- SoupGate-Win32 v1.05