Message-ID: 
Newsgroups: AIRGUN.LIST
Organization: Mac-1 
Gloria Hardcastle wrote:
> 
> MAC-1    I have a Crosman Model 111 and the 10 oz tank didn't
> accompany
> it.  I also have a concession stand bulk CO2 tank.
The tank you have has to be inverted to transfer liquid to a tank you
are filling. You must give the small tank what it will take and then
blow that off to chill the tank. The alternative is to put the 10 oz
tank in the freezer for 30 minutes. Make sure you don't put/leave more
than ten ounces in the ten ounce tank cause it will physically take much
more but is not safe to do so. So it is best to do this with a scale.
When you blead off a tank to chill it it must have the valve at least
horizontal if not facing up to get it to schill properly. When you first
see a little vapor and frost the tank is cold enough to receive a full
charge. Don't overfill/overblead. It is just a waste of gas.
  What else do I
> need to get this pistol sending pellets downrange? 
You'll need the $7.50 adapter to fill a tank from the master tank.
A $10 adapter to fill a 111 from the painball tank.
And a ten ouncer with an on/off valve ($25).
We can send just the 2nd and 3rd items and that will come full. You can
try it out and if it holds you can get the adapter for $7.50 but that is
hardly worth the shipping costs you'll incur. Be sure to provide us with
your address for proper UPS quote.
 I'm not sure the pistol
> holds so I would like to start off as inexpensive as possible.
>   Thanks Eugene egh@hal-pc.org
The important thing when you go to charge the pistol is to make sure
that it is warm, cocked, bolt open, and unloaded. It won't charge if it
is not cocked. If you get it really warm B4 the charging attempt an old
tired valve has the best chance of taking a charge and holding it.
Good Luck.
Tim
-- 
MAC-1 Airgun Distr./McMurray & Son   Phone 310-327-3581 FAX 310-327-0238
http://www.mindspring.com/~airguns/  Hours-M,Tu,F,Sa 11:00AM-6:00PM PST
13974 Van Ness Ave.                  Tim McMurray
Gardena, CA 90249 USA                mac1@concentric.net
--- QScan/PCB v1.19b / 01-0671
---------------