-=> Quoting Erik Jakobsen to all <=-

Your message was flagged Private, so most folks never even saw it.
Also, your "diagram" was so badly mangled I couldn't figure it out. 

 EJ> Hello !

 EJ> How do I do the following :

 EJ> |     server running      |
 EJ> netcard1             netcard2       
 EJ> net 1 (bnc) ---------------|     os2 warp 4     |
 EJ> ------------------(TP) net 2  or
 EJ> os2 warp serv entry 

 EJ> tcpip: X.Y.Z.1-32 ( 255.255.0.0 )                ( 255.255.0.0 )
 EJ> X.Y.A.1-32 I want to connect  2 diff local networks on 1 server ...
 EJ> might be running os2 warp og warp server entry  i want to be able to
 EJ> use netbios over tcpip or just tcpip to connect the two sides.  
 EJ> Is it possibel and how might it be achived ? 
 EJ> 
 EJ> I've tried but the bnc-netcard alway get disabled, ( error on irq) 
 EJ> protocol.ini does have entries to cover the netcard, but it doesnt
 EJ> function.  I'v tried 2 identical pci-netcards with diff addresses 
 EJ> i'v tried 2 different pci-netcards 
 EJ> the bnc (or both) allways gets disabled.

At a guess, if you are trying to use both BNC and RJ-45 connectors on
the *same* card, it's not possible. You'd need different cards. One for
each type of connector. 

Unless you *need* the two networks to be seperate, just buy a hub that
has a BNC connector. That's how I've hooked my old BNC machines into
the network with my newer TP (RJ-45) systems. 

If you *do* need them to be seperate networks, you may be able to do
it, but you'll need two cards. And probably two IP addresses. Beyond
that, I have no idea.

--- Blue Wave/DOS v2.30