On 28 Apr 98 08:04am, Derrick Neve wrote to All:
 DN> Is anyone using this combo?
 DN> Speedeasy motherboard and an AMD 200 MMX CPU.
 DN> It automatically detects a 166 whereas it *is* a 200 MHz chip.
 DN> If I set it to 200 manually my boot on CONFIG.SYS will hang
 DN> just after installing the network card. Can't go any further.
 DN> So I reset it to 166 and all is happy.
I recently ran into this problem with Cyrix 6x86 processors (200Mhz seen
as 66Mhz chips) when installed on DFI (Diamond Flower) MLB's.
The solution was to get a flash bios upgrade (code and loader) from
their internet support site.  Chances are, that's what you'll need with
the Speedeasy board and your AMD processor.
George
... At 34 nobody will feel the heat more than him.
--- Via Silver Xpress V4.4P [Reg]
---------------