In a msg on , Jussi Hamalainen of 2:221/376
writes to Zorch Frezberg:
 ZF>> So, what is the command line string you use to fire it up so 
 ZF>> it can be _seen_ over a telnet session? 
 JH> What do you mean? If you mean that with what parameters do you 
 JH> fire up Max so that it works over telnet? Just give it the 
 JH> port COM/IP and WinFOSSIL use and a baud rate. If you have a 
 JH> fast line, 38400 is nice. It should work if you have the port 
 JH> COM/IP uses configured into WinFOSSIL.
Did it.  Both ways.  COM/IP set with
        AT S1001=2 S1002=1 &C1 &D0
on COM5, with and without WinFOSSIL.
One demands FOSSIL, the other goes into LOCAL mode.
Tried COM5 redirected to COM3.  Same thing.
Start-up command is
       d:\max\max.exe -s%1 -b%2 -p%3 
If I use the "-t%4" switch, it goes to TIME LIMIT and shuts down.
-zf-
--- msgedsq 2.1
---------------