-> I am using qmpro v1.53..... how do you get out of the program to run
-> a terminal program that is required on some BBS doors. I used procomm
-> plus for a number of years and never had this problem, but since
-> switching to qmodem, I have never successfully pulled it off.
i believe you can do this a couple of ways... Usually however the BBS
DOOR comm program willtell you how to set it up for themajor comm
packages outthere. but here are some suggestions.
1> you can SHELL out to dos, then run the program, or
2> EXIT QMPRO leaving the DTR signal UP, in other words when it asks you
drop to dos Yes, or No or eXit leaving DTR up, then pick the X leaving
your DTR up, you will have to RESTART  QMPRO when your done, but your
DTR signal will remain up this way allowing you to continue while
online...  good luck...
Kris Steele
--- QScan/PCB v1.16b / Evaluation copy
---------------