-=> Quoting Craig Hart to Serguei Shtyliov <=-
Hi Craig,
Even with TASM 5.0's version of TD you still havent got the
option of entering asm like DOS's debug does,
but yes it does allow you to enter raw code i.e:
 '00fh 022h 0c0h' = mov cr0,eax
 
 >  DT>> where can i get a debugger which works with 32 bit
 >  DT>> instructions and works in all modes not just protected
 >    Sorry, I haven't noticed that you want a debugger for all modes -- TD
 > is certainly not the case. But it recognizes 386 insns at least. :)
 > Probably Watcom debugger could help but I have no experience with it...
 CH> 'scuse me.. . noticed you were discussing TD. Hope you might know
 CH> something... 
 CH> TD 3.2 is a pain the the butt...  It won't accept mov eax,cr0 typed in
 CH> at the keyboard for example, but it will disassemble it quite happily
 CH> from inside an executable. Do you perchance know if a later version of
 CH> TD fixes this? I often use TD to 'hand enter' small blocks of code on
 CH> a 'lets try this idea' basis, but bieng unable to get TD to accept
 CH> CRx, DRx etc really annoys me!! 
 CH> Craig
One other thing I found the other day is if you in your
config.sys - HIMEM.SYS /int15=4096 (reserve extened memory but make above
                                    this XMS memory.)
and try using TLINK my machine falls tits over arse,
has anyone else experienced this?
cya paul
... HD Recovery: see online documentation....
--- EzyBlueWave V1.20 01fb000b
---------------