Hello David.
Thursday May 14 1998 06:28, David Drummond wrote to Bill Grimsley:
 DD> Bill, at 07:05 on May 12 1998, you wrote to Joe Kovacs ...
 JK>>> In the case of USR modems, &F0 initiates software flow
 JK>>> control.
 BG>> My Sportster's on-line help screen (AT&$) suggests
 BG>> otherwise...
 BG>> &F0 = *NO* flow control
 BG>> &F1 = Hardware flow control
 BG>> &F2 = Software flow control
 BG>> Are the Couriers' &Fn templates not the same?
 DD> Mine says:
 DD> &Fn
 DD> n=0  Load Factory Configuration
But I wonder if we have found a little 'buglet' here. Mine says the same when 
using the AT$G command but the manual specifically says;
&F0 No Flow Control Template
It also states that with DIP switch ON, the &F0 template is loaded when the 
modem is powered ON.
The above is shown in my USRobotics COURIER High Speed Modems,
Courier V.34-Dual Standard V.34-Ready FAX manual, page B-13.
 DD> n=1  Hardware Flow Control Cnfg.
 DD> n=2  Software Flow Control Cnfg.
 DD> n=3  HST/Cellular w/ HW FC Cnfg.
Bob
... If at first you don't succeed, skydiving is not for you.
--- D'B 3000A3/GoldED/386 3.00.Beta3+REG#434LM15/TAG 2.7d
---------------