I've contacted (M) on this, but the part is no longer in their system.
I need the connector (or schematic of) that allows you to put the tranceiver 
into the 'Manual Test Mode'.  It is simply called an "In-Line Test 
Connector", and the obsolete (M) PN is 30-84406R01.  If someone has worked 
out a pinning diagram for this tool, I could probably manufacture a 
replacement unit with a couple DB-25's as this tool inserts between the 
'brick' and the DB cable connector.  I imagine it is simply putting voltage 
(or grounding) pins that are not usually so configured.
My reason for needing this tool, is to place the tranceiver in the 'manul 
test mode' for programming of negative system ID's to be used in the C-Scan 
Mode.
All the Best to you and yours,
       Bruce LeGrande
           NC2003
--- GEcho 1.11+
---------------