RW> I did a write similar to this many years ago (1980-1) using a TI-994A in
 RW> Basic to triangulate signal reports using grid squares on a Thomas Bros 
map
 RW> book. It always referred me to the right page, but was usually a couple 
of
 RW> squares off and never consistantly so.  Thomas Bros wasn't forthcoming 
with
 RW> any information I needed (scale) in perfecting the program, so I gave it
 RW> up..
 I remember seeing something like this ona disk of mine.
 You had a sheet of papaer with squares marked in numbers on it on the X and 

axis and used those numbers to get a general bearing from the software.
 Tried it a few times without much success.
 RW> Are you going to UUEncode that software with it?
 No..sysop may not like that,its around 900K in size!
 I will post a listing of the BBS and Internet addresses where it can be
downloaded from in part 3 of my post on DF-ing.
--- GoldED 2.42.G1219
---------------