Hello Mike,
On (Fri  9 Ja) cybercadet Mike Martin wrote to Phil Heberer...
 MM> I have tried W , W1, W2 and all three show the port speed upon connect
 MM> (115200) not until I set the S95 register to 1 do I get the modem
 MM> speed.
 MM> here is my init:
 MM> AT&F2&D0S95=1S11=35
 MM> Is this the correct way to get the modem connect speed?
This is the Active Profile that I am presently using with very good
results:
ACTIVE PROFILE:
B1 E1 L3 M1 N1 Q0 T V1 W1 X4 Y0 %C0 %E0 %G1 &C1 &D2 &K3 &Q5 &R1 &S0 &X0
S00:000 S01:000 S02:043 S03:013 S04:010 S05:008 S06:002 S07:060 S08:002
S09:012 S10:014 S11:055 S12:050 S18:000 S23:054 S25:005 S26:001 S36:007
S37:000 S38:005 S40:104 S41:128 S44:128 S46:136 S48:007 S91:010 S95:041
S109:062 S110:014
Most of these were selected by ProComm Plus terminal program when
configuring for the Supra Express 33sp.
This is the Active Profile after an AT&F2, just for comparision.
B1 E1 L2 M1 N1 Q0 T V1 W0 X4 Y0 %C3 %E0 %G1 &C1 &D2 &K3 &Q5 &R1 &S0 &X0
S00:000 S01:000 S02:043 S03:013 S04:010 S05:008 S06:002 S07:050 S08:002
S09:012 S10:014 S11:095 S12:050 S18:000 S23:054 S25:005 S26:001 S36:007
S37:000 S38:005 S40:104 S41:131 S44:131 S46:138 S48:007 S91:010 S95:000
S109:062 S110:014
I change L3, W1, %C3, S7=60, S11=55, S41=128, S44=128, S46=136, S95=41
and have had very good results lately.
I have the 336_LIST.TXT with the AT commands around here someplace that
gives some additional explanation to the Supra manual but it's not
handy. Otherwise I'd explain a little better what each of those
commands do.
Just for chuckles and grins, you might leave out the &D0 in your init,
and change S95=41 to see if that improves your connects at all.
Cheers,
Phil
... I am in shape ... ROUND's a shape isn't it!?
--- PPoint 2.05
---------------