-=> KHILE KLOCK wrote to BOB LOTSPEICH concerning Wirdness with SFM 28.8 
(Ext) <=-
 KK> What I HAVE noticed though is that if you set S95 to a high value,
 KK> like I have mine at 43. Save everything into NVRAM, and always
 KK> initialize the modem aith ATZ, that those junk characters appear.
 KK> If I set S95 down to something like 4, it goes away... When I set it
 KK> back up to S95=43&W. It's gone for the first call, then it re-appears.
 KK> Can someone verify this with me? (Try it! )
Your S95 should be set to: S95=3. This will give you the correct
result codes.  Do you have Caller ID on your modem line? If so, make
sure you set your NVRAM to: #CID=1.  Here are the settings I use on my
modem:
AT&V
ACTIVE PROFILE:
B1 E1 L0 M0 N1 Q0 T V1 W2 X4 Y0 %C3 %E0 %G1 -K0 &C1 &D2 &K3 &Q5 &R1 &S0 &X0 
&Y0
S00:000 S01:000 S02:043 S03:013 S04:010 S05:008 S06:002 S07:050 S08:002 
S09:012
S10:014 S11:055 S12:050 S18:000 S23:062 S25:005 S26:001 S36:007 S37:000 
S38:005
S40:104 S41:131 S44:131 S46:138 S48:007 S91:010 S95:003 S109:062 S110:014
STORED PROFILE 0:
B1 E1 L0 M0 N1 Q0 T V1 W2 X4 Y0 %C3 %E0 %G1 -K0 &C1 &D2 &K3 &Q5 &R1 &S0 &X0
S00:000 S02:043 S06:002 S07:050 S08:002 S09:012 S10:014 S11:055 S12:050 
S18:000
S23:062 S25:005 S26:001 S36:007 S37:000 S40:104 S41:131 S46:138 S95:003
STORED PROFILE 1:
B1 E1 L0 M0 N1 Q0 T V1 W2 X4 Y0 %C3 %E0 %G1 -K0 &C1 &D2 &K3 &Q5 &R1 &S0 &X0
S00:000 S02:043 S06:002 S07:050 S08:002 S09:012 S10:014 S11:055 S12:050 
S18:000
S23:062 S25:005 S26:001 S36:007 S37:000 S40:104 S41:131 S46:138 S95:003
TELEPHONE NUMBERS:
0=                                    1=
2=                                    3=
OK
Hope this helps...
--- Blue Wave/386 v2.30
---------------