Howdy everyone,
I'm trying to setup to recieve faxes running my BBS (TransAmiga) with 
Trapdoor and using GPFax. I was testing with the FaxBack service, but each 
time trapdoor passed the cmd +FCON  and GPFax said recieving fax...the 28800 
would reset right after it said Fax on the display, and the transfer never 
gets going. I have tried a few different modem inits, but they all did the 
same, a couple I got from a friend in the UK and one I got right out of the 
GPFax manual. Here they are:
Part of my Trapdoor .cfg
FAXSTRING "+FCON"
FAXCOMMAND "rx \"address REXX_GPFAX fconreceive\""
; Inits from John...(UK) He got them from a fido posting.
;With my SupraFaxModem v.32bis I lock at 38400, and use the following init:
;MODEMINIT "AT&F2X4M0E1W2#CID=1S95=2%E1+FCR=1+FAA=1+FLID=\"654-9424\"|~"
;With my new SupraFaxModem v.34 I lock at 57600 and use the following init:
;MODEMINIT "AT&F2#CID=1W2+FCR=1+FAA=1+FLID=\"654-9424\"|~"
; My Orig init
SLOWMODEM 10
MODEMINIT "~~AT~~Z0|~~"
MODEMHANGUP "^|^"
MODEMDIALPRE "~~~~~~~AT~~~~~~~DT"
MODEMDIALPOST "|~"
MODEMANSWER "~~AT~A|~"
; GPFax Init
;MODEMINIT "AT&F2+FCLASS=0+FAA=1|"
;MODEMHANGUP "||^|~~~+++~~~ATH|"
;MODEMDIALPRE "~~AT+FCLASS=0;+FAA=0DT"
;MODEMDIALPOST "|"
;MODEMANSWER "~~ATA|"
;
I had no luck with any of these at all, if anyone has any ideas, it would be 
appreciated. Thanks in advance.
Regards,
Wolf...
  (Oo)  WoLfGaNg ErNiCkE    *Team AMIGA*  EmAiL- wernicke@pangea.ca    (oO)
  \__/  ClAwBoNe HoMePaGe       http://www.pangea.ca/~wernicke/        \__/
... Fido's been a bad doggy again... Naughty Fido..
* Pick-Tag v2.5 *
--- TransAmiga BBS v1.23f 
(1:348/707@FidoNet)
---------------