Message-ID: 
Newsgroups: AIRGUN.LIST
Organization: Mac-1 
Reames wrote:
> 
> Hi Tim, I got a stealth today, I ordered from John, BEFORE I knew you
> would
> be handling them. My question concerns the adapter. The 1/4" male
> thread is
> british thread, right?  I know they have both straight, and taper, and
> I
> want to be sure berfore I set up the fill adapter This one looks
> straight.....  Thanks.  Mike
It is made in Texas but that's no guarantee that it won't be a british
thread. I don't know.
I haven't got the adapter to look at. I thought they were tapered. You
should be able to screw them into any basic yoke as most use 1/4 pipe.
I'm going to make an adapter that you can hook it up to the -4 on the
end of a Career hose. Then another that will hook to the end of that
funky british thread that they always have on the hoses. Between those
two I'll be covering the majority of the guys that'll want to use ione
of there existing fillers rather than spend the nmoney for another
yoke/gauge/bleeder @ $70+.
Later
Tim
-- 
MAC-1 Airgun Distr./McMurray & Son   Phone 310-327-3581 FAX 310-327-0238
http://www.mindspring.com/~airguns/  Hours-M,Tu,F,Sa 11:00AM-6:00PM PST
13974 Van Ness Ave.                  Tim McMurray
Gardena, CA 90249 USA                mac1@concentric.net
--- QScan/PCB v1.19b / 01-0671
---------------