Russ Parks wrote in a message to Mario Semo:

 MS>         .MODEL FLAT

 RP>  This is one possible problem I'm having. The version of
 RP> MASM I have doesn't support FLAT anything... maybe it's time
 RP> to upgrade again :) 

Use ".386p" and ".MODEL NEAR" to get the same effect as
".MODEL FLAT" in MASM.

 MS>         ALIGN 04H

 RP>  AHA! This could also be where I'm going wrong... alignment
 RP> is the obvious booger :-)

The ALIGN directive does not align the segment, but only aligns your
address counter within the segment.  You need to specify segment alignment
as part of the SEGMENT directive.

 RP>  I'll try it out later tonight. Getting around the .FLAT
 RP> model shouldn't be too much of a problem -- just gotta get
 RP> that alignment right.

All of the magic -- "USE32" and "PARA" -- goes in the
segment directive.
 
-- Mike


---