SM> Modem works on Comm 3 under the following configuration....
 SM> Ser 0   disabled
 SM> Ser 1   enabled
 SM> IRQ 4   enabled
 SM> However, because my mouse is on Comm 1 and is using IRQ 
 SM> 4, I am trying to find
 SM> out how I can get the modem to work on IRQ 3,  Comm 2.  
 SM>  So far, I have not 
 SM> found the correct configuration.  Also, because this is 
 SM> a PC which I have just
 SM> acquired, and have not yet seen Comm 2 working, I am 
 SM> not positive that Comm 2
 SM> is in fact a working port.  Although MSD and Windows 
 SM> show Comm 1, 2, and 3 
 SM> as all set up to work.  Once I get the correct configuration, would it 
be 
 SM> possible for me to use the Comm 3 port because I know that it works?
If MSD and Windows show Comm 1, 2, and 3, then you'll need to disable comm 2 
on the I/O card that has your comports and enable comm 2 IRQ 3 on the modem.
Unless you have something currently attached to comm 2, then you won't see it 
working.  Since it shows up in MSD and Windows, it is enabled.
Hope this helps!
--Kevin
--- GEcho/32 1.20/Pro
---------------