Hi
I have a Suprafax 288i modem and am trying to run it on my Northgate 386.  
I noticed that there are a series of jumpers which are labeled as follows
Ser 0    Ser 1    Irq 2   Irq 3    Irq 4    Irq 5
Modem works on Comm 3 under the following configuration....
Ser 0   disabled
Ser 1   enabled
IRQ 4   enabled
However, because my mouse is on Comm 1 and is using IRQ 4, I am trying to 
ind
out how I can get the modem to work on IRQ 3,  Comm 2.   So far, I have not 
found the correct configuration.  Also, because this is a PC which I have 
ust
acquired, and have not yet seen Comm 2 working, I am not positive that Comm 2
is in fact a working port.  Although MSD and Windows show Comm 1, 2, and 3 
as all set up to work.  Once I get the correct configuration, would it be 
possible for me to use the Comm 3 port because I know that it works?
Any help would be greatly appreciated. :)
--- Renegade v5-11 Exp
---------------