Hi Ricky ! 
 
       In response to your pixels originating Sun Aug 24 about Supra 288i PnP
 RH> I have a SupraExpress 288i PnP modem, I cannot get my system to
 RH> recgonize it.  I run a 486 dx 25 IBM.  I dont know why windows cant
 RH> find it but it cant.
I'm guessing here, so take this advice with a grain of salt. I just installed 
a 336i PnP on my 486, and have made some progress, not done yet. 
It seems that the plug & pray looked at my motherboard serial ports, and set 
up some (at least as far as legacy systems are concerned) nonstandard com 
settings for the PNP modem. The two things I did that resolved most of the 
problems were: going into CMOS setup, and disabling the motherboard com 
orts.
Then I ran the ICU configuration utility that came with the SUPRA and 
manually configured the supra to com 1. Things are better now, but still 
don't have everything configured for binkley. My old init strings still need 
some changing since (I think) these new critters are no longer fully "hayes 
compatible" and some of the old commands don't work. 
CU L8 R,
 
                   - Robin 
    robin.kelly@nest.conchbbs.com 
--- timEd/386 1.10
---------------