Hi,

On 2013-05-10 12:58:30, mark lewis wrote to all:
  about: "fmail 1.48":

 ml> i haven't found it so i'm asking... is there any way to have fmail
 ml> 1.48 automatically add areas being fed from an uplink instead of them
 ml> going into badmail and then having to manually run setup to manualy
 ml> configure the areas with a final run to retoss the posts from the
 ml> badmail area into the proper area??

 ml> it would be so much easier if i could just flip a switch on the feed's
 ml> record to automaticall add the areas with defaults and boogie on...

You will have to upgrade to atleast the 1.60 version:

NEW FEATURES IN 1.60
====================
...
- FTOOLS ADDNEW function has been added. If you run this command after new
  areas have been received (FMail Toss), these areas will be added to
  FMAIL.AR (using the defaults you set on the AreaMgr defaults page in
  FSetup). After that, you can run FMAIL TOSS /B to retoss the bad messages.
  You can detect the arrival of new areas by testing from your batch file
  whether or not FMAIL.BDE exists in the FMail directory.
  If you add the switch /A, the files that are normally updated by FSetup's
  AutoUpdate feature, will also be updated by FTools AddNew.
...


Bye, Wilfred.


--- FMail-W32-1.64-B20111120