Hi There.

I have a DX4-100 with plenty of gear, but most importantly...

Telix for Windows v1.15d
High Speed UARTS 16550AF (According to MSD)

I am using a standard 7 wire NULL modem cable connecting to my

A4000
GVP Serial Card.

I am trying to connect to my BBS on the A4000, but the best rate i can get
is 19200, any higher and i get errors during downloading. I have hardware
flow control turned on and all rates set at 38400 on the IBM and i have the
same setup on the Amiga as i did when i had a A1200 connected at 38400
(which zooms along without any hassles)

So why would the dx4-100 be having troubles at 38400. I was hoping to even
get up to 57600 as both machines should be able to handle that.

Any suggestions appreciated.
+                                                                           +
 Contact Ivan Wheelwright (EXTRA-BIT) || Internet: ivanw{at}attic.apana.org.au
 The ATTIC BBS ++61 8 3844762         || Fidonet:Ivan Wheelwright{at}3:800/443
+                                                                           +
--- CNet/3