On Tue, 31-Mar-1998 07:48; Bob Juge writes:
 RI> Or can I flash straight to V.90 (secondary question being -- must 
 RI> I then also enable x2/V.90 thru the 3Com BBS)?
 BJ> If your modem has previously been made x2-capable, all you need do
 BJ> is apply the 3/13 SDL to enable x2/V.90.
Thanks Bob.  Even the web page is a bit unclear (after all, I suppose why 
would anyone flash back to earlier code, eh?).  
My thought was that perhaps the x2-enable key was 'stored' in the same memory 
area the actual modem code was; and it'd get 'wiped clean' on every re-flash. 
 I'll take the plunge... tomorrow.  :-)
Regards,
  Robin
--- FastEcho/2+ 1.45a
---------------