Hello Mike.

23 Oct 04 22:11, you wrote to me:

 MR> If you are running a batch file to start the start.bat ( usually do
 MR> when running igms, make sure your paths are right for that too. I run
 MR> straight from start.bat, but in the past I had a lord.bat call the
 MR> start.bat and after the game some maintenance would run for some igms.
 MR> I don't know your set up.

 MR> If your paths are right in start.bat. In Telegard, I just call the
 MR> door and pass the current node number on to it. Also, I know it sounds
 MR> stupid. but make sure the paths in lord config, match for each node.
 MR> for example here it would be c:\telegard\node1  for the path to
 MR> door.sys on node one. Now if in a hurry, I may have that for node 2
 MR> and am screwed in the lord config. Just trying to think of anything
 MR> that could be throwing you a curve. Good Luck

Just tried "start 1" in the lord directory, and it hangs Opening
"door.sys"

There is a door.sys file for node1 in c:\doors\node1

Not sure that this is meaningfull or not, might be some other that I am not 
aware of/overlooking. 

Will check my paths again, maybe I will find the "culprit" that has been 
passing under my eye un-noticed thus far.

Thanks,

Russell

--- GoldED+/LNX 1.1.4.7