In a message of , Charles Miller (1:206/2406) writes:
 CM> >  Just how do you do that?  I tried using the WSGen of Novell 3.11
 CM> > but the option to change the frame never came up.
 CM>If you are using VLM's, it is in NET.CFG file.
If you are using the ODI stack, with the VLM's or with Netx, it is in the 
Net.cfg file, otherwise you must run econfig on the ipx.com executable after 
it has been linked. This latter method is long since obsolete.
The frame type option is not VLM dependant, it goes in the Mlid (card driver) 
section of the net.cfg file.
Regards,
        Richard.
--- Msged/Q 1.60
---------------