Re: WYSE WY2108-01 SETUP Utility

>  CG> Is there anyone out there that a WYSE WY2108-01 PC that knows how to
>  CG> get into the SETUP utility?  Can you get into it via keystrokes durin
>  CG> boot?  If not, do you have the executable that you have to run?
> You should be able to do that.   Have you tried the obvious like
> F8, ESC and DEL?

Yep, tried all the obvious single key and key combinations that I could think
of to get into it.  Either I am not hitting the right key, the right key
sequence, the right combination of keys, or this WYSE WY2108-01 won't enter
SETUP any way except by running an executable.  It is an old 80286, and has the
oldest of hard drives - an MFM interface 20MB Seagate ST225, and only a 5¼"
Floppy and uses an old terminal for a display.  Computers couldn't get too much
older than this except for XTs and the such.

CW

--- Virtual Advanced Ver 2 for DOS