I have been trying to get a simple led project to work on my pi 3 using
a 5 volt 6 amp power supply and a 510 ohm resistor in front of the led
to reduce the current going to it. Now after trying different tutorials,
my pi 3 goes off on it's own from being powered up.

If I remove the power lead and restart the pi 3 the red comes on and the
green led flashes as well as the ethernet port flashing green led.

I ssh into the pi 3 to try and run a python program, but then the pi
dies, and there are no lit up leds anywhere at all on it.

Is there any way it can be fixed or should I just forget about it.

--- SoupGate-Win32 v1.05