Hello Russell!
Sunday March 29 1998 08:07, Russell Brooks wrote to Bob Wingender:
 RB>>> Turn smartdrive for WINNDOS AND DOS, OFF with the x switch
 BW>> I don't, and won't, use Smartdrive...
 BW>> I use Hyperdisk and had no trouble using it prior to the disk
 BW>> crash.
 BW>> I just tried a file transmit and got no errors. The errors only
 BW>> occur on inbound
 RB> Then you must have software flow control set in either your modem or
 RB> software or both.
Nope.. Hardware Flow Template. Using AT&F1.
 RB> I installed one particular SDL once that reset all my settings and
 RB> changed my hardware flow control to default to software.....bad
 RB> mistake.  I did not know what hit me when I used the modem straight
 RB> after flashing it, to upload the new SDL across the country.
 RB> No fault of my own, either... gremlins in the SDL did all the work.
 RB> just take a peek to be sure.
I believe it's been mentioned in here before to do an ATZ after a new flash 
just in case the registers get set wrong. I personaly haven't had any of them 
change but just to be safe, I expanded the USR.CFG file to be used when 
flashing. Here is the one I use to flash the x2/v90 code;
=== Cut ===
AT
AT&F1
ATS7=55
ATS11=50
ATS10=14
ATS58=0
ATS59=0
ATS60=0
ATS61=0
ATS69=0
ATS70=0
AT#CID=0
AT&U0
AT&N0
ATT
AT&W
=== Cut ===
The first 4 and next to last items were added by me.
I flash the modem, with phoneline disconnected, locked at 57600, to 
Com1/IRQ4. After it is reported that the flash is OK, I load my Term program 
and check each parameter to see if it is right using ATI4, 5, 6, 7, etc.
                               -=[Bob]=-
Internet:
rwingend@mail.orion.org
classa1@juno.com
... Could I put a PC, modem and cellular phone on my boat?
--- D'B 3000A3/GoldED/386 3.00.Beta3+REG#434LM15/TAG 2.7d
---------------