Paul, at 21:07 on Mar 28 1996, you wrote to Bill Grimsley...

PE> And where does the manual say that autobauding doesn't work on
PE> ATZ?  NOWHERE. 

BG> No, but the manual DOES tell you that you need to write any baud change to 
BG> NVRAM with AT&W.  

PE> No it doesn't.

BG> Fucking bullshit.  I've already posted that part of the manual which states 
BG> this, so I won't be bothering again. 

PE> It doesn't.  You have only ever been able to post irrelevant stuff.
PE> Your favourite is the &B2 when I am using &B1.

Have a quote then...

-----------------------------------------------------------------------
The following command example substitutes several user-defined defaults 
for factory settings.  The modem also stores the port rate, word length 
and parity it detects from the AT command prefix.

         AT X1 &B0 &M5 &H0 M3 &W 
-----------------------------------------------------------------------

And another....

-------------------------------------------------------------------------
Word length*               8
Parity* 0                  None
DTE rate* (Kbps)           19.2    _

*  Detected by the modem from the AT prefix of the &W command that 
   writes your defaults to NVRAM.  Set your software to the desired word 
   length, parity, and serial port rate defaults before sending the modem 
   the AT . . . &W string.
--------------------------------------------------------------------------

If that's not clear enough for you, I give up.

Regards, Bill

--- Msgedsq/2 3.20