07 Aug 2005, 07:43, THURSTON ACKERMAN (1:123/140), wrote to MATT MC_CARTHY:

Hi THURSTON.

 MM>>Do the paper feed rollers still turn?

 TA> No.

Then there is not much hope other than to check the seating and connections
of the cables from the drive motor to the board.  

The linefeed signals are either not getting from the processor to the
driver chips, or from the driver chips to the motor.  If you can 'unplug'
or 'release' the cables and re-seat them with no benefit, it is probably
going to be too difficult to trouble shoot, and I would have to agree with
the 'boat anchor' scenario!   :-((


     Good luck...  M. 

--- Msged/386 TE 06 (pre)