SD> I don't recall getting a reply to my inquiries.  
Sorry...Please see the Next Message as I'll repost it!!!
 SD> Don't forget that Maximus itself does not directly 
 SD> address the com port.  Some sort of FOSSIL driver is 
 SD> required between Maximus and the Digiboard, and that 
 SD> too is a potential source of problems.
I'm using DigiFossil 2.2 as it is the only fossil made for Intelligent 
Digiboards and is recommended by Digi International!!! I load the nodes in a 
Desqview Window and the Fossil portion is loaded before Desqview as said in 
the Digifossil Docs!!! When I load my Window in Desqview it loads the TSR 
part of Digifossil which stresses the Com Port and Locks the Baud Rate!!! It 
then loads FrontDoor and waits for A caller!!! I get very frequent Mail Drops 
from different sources for 4 Different Nets including Daily 50 Meg Internet 
Drops and I call out almost every night to local BBSes doing file transfers 
from the Mailer term Program!!! I get great transfer rates and nothing 
appears to be going wrong which suggests the Modem, Digiboard, Fossil, and 
Frontdoor are all working fine BUT when a user drops from the Mailer to the 
BBS, Maximus starts a constant repeating of the Login Line "What is your 
name" and the speed is as fast to allow a user only a chance to get 1 letter 
in per line!!! I should also mention that I've had my ISDN modem hooked up to 
the Digiboard with Digifossil 2.2 and FrontDoor since last November without 
any problem on a 3rd node!!! The only problem happens when it tries to load 
Maximus up in Dos!!! Can you figure this out???
P.S. I should also mention that I took the Mailer offline and loaded the 
Fossil, Desqview, Fossil TSR, and then Maximus in the Waiting for Caller Mode 
and had the same effect & problem!!! I have been working on this since last 
November so I'm a little tired & frustrated with this and after talking with 
all the Hardware & Software support people from my setup they all point the 
finger at Maximus!!! I'm just hoping that you'll be able to get this working 
even it it comes down to running a small patch or something!!! :(
  
--- Maximus 3.01
---------------