SP> Frank Ramsey wrote in a message to Bruce Bodger:
 FR> Dismount the volume.  LOAD INSTALL.  Select the volume to
 FR> rename and press ENTER.  Select the volume name, press
 FR> ENTER.  Type the new name, press ENTER.  Press ESC and
 FR> answer Yes to the change name question. Remount the volume. 
 SP> Can you do this with SYS VOL?  I will have to enlarge/replace our 
 SP> main drive and wanted to rename SYS so I can add it as a third
 SP> volume without deleting anything on it.  It would also be interesting
 SP> to see if I could NCOPY the whole thing back over as a restore method.
Yes, but it's a little more difficult.  Start the server, but don't run 
STARTUP.NCF or AUTOEXEC.NCF.  Use SERVER -NA -NS. Then load the disk 
interface.
Load INSTALL and you'll see the SYS volume available.  You can then select 
the SYS volume and rename it as above.
Trying to clone the server by NCOPY isn't going to work very successfully.  
You'll loose accounts, printer definitions and trusteeships.  You can run 
BINDFIX and BINDREST to get accounts back, but not much else.
framsey@goodyear.com; CIS 71631,1032 - CNE, CNA-4, PE
--- EZPoint V2.2
---------------