Hello Rod!

I got my serial port card back from my brother-in-law.  Now I have a COM1,
COM2, COM3 and I have configured COM4 but it doesn't really exist.  Under
vanilla DOS, I can make Telix access COM2 and COM3 successfully.  Under
OS/2 I can only access COM2.  COM3 cannot be accessed from either Binkley
or Telix. It says that the port cannot be initialized.  Any ideas?

The card with COM1+COM2 on it uses a 16450.  There was only one 16450, so I
presume that handles both com ports?  It looked like the chip was socketed
too. I thought you needed one of these chips for each com port?  COM3 has
an 8250 in it.

Paul

--- GoldED 2.40