Mark, at 09:36 on Feb 24 1996, you wrote to Joe Frankiewicz ...

MH> I just tried the new 1/23/96 FLASH code in my single board
MH> V.Everything. I had to go back right away to the older code. 
MH> The flash took just fine. I did an AT&F1 and added the 
MH> commands that were in the config file. Then saved it all with 
MH> &W. I can call out just fine but when a call comes in I can 
MH> see the AA light flash but RING is not sent to my software. 

. . .[chomp]. . .

If your init string is ATZ, the modem will reset to the port speed stored
in NVRAM by the last AT&W or SDL flash.  Ensure that your mailer/bbs
software is set to the same port speed (or that your modem is AT&W'ed
at the port speed you have your software set to)

David
@EOT:

--- Msgedsq/2 3.10