-> On Nov 17, 2018 08:03pm, Lee Green wrote to All:

->  LG> Is the Fidonet Netmail echo suppose to be processed with the other
->  LG> Fidonet echo packets or separate from it?

->  LG> At one time I had it that way and my uplink said my netmail was coming
->  LG> in with the regular echo packets and wasn't suppose to work like that
->  LG> that they should be separate.

->  LG> I was able to get ONE netmail to go out but that was only to my uplink
->  LG> all the others are sitting there in the netmail conference and
->  LG> netmail queue with a status of "Pending" whatever
that means, if I add
->  LG> the netmail echo with the other fido echos these other netmails
->  LG> will go out.

-> They usually DO go out separate based on destination node.  Could you give a
-> little more detailed explanation as to what problem you are having?  And you
-> might also want to scan out netmail using the PXNET.EXE command like so:

The only netmail that goes out is when I send one to my uplink 1:218/700
all the other netmails to others just sit there, they are seen by pxnet
they just don't get put into a packet ever. I receive all INcoming
netmail fine. I believe Ruben is having the same problem.

-> PXNET.EXE /scan /fastpack 

That's what I use, and it runs from between.bat

-> This will pack up your outbound netmail for  and mark it
-> as read in Wildcat!.  I have this command run in my Internet Rex BETWEEN.BAT
-> file for each system I connect to to make sure any netmail destined for their
-> systems is packed and ready to go on the next mail run.  Als, you might want
-> to check and make sure your routing is set up correctly for netmail as well.

Where is routing for netmail located? I think I've checked everything
multiple times.

-> ... Platinum Xpress & Wildcat!.... PITA !!!
-> --- Platinum Xpress/Win/WINServer v3.0pr5
--- Platinum Xpress/Win/WINServer v3.0pr5