The following questions probably belong in a different area, however, I am
currently not subscribed to anyother areas, therefore, I will post my
question here in hopes that someone will be able to help me out.

I am running OS/2 Warp Connect Version 3 on a 386/40 w/ 8Megs RAM on a
TCP/IP printer.  I have set up the network to use LPR to print one of my
Linux servers, and this works fine from OS/2 Command Mode (ie: I can do
"type temp.txt | lpr" and it will print), however, I cannot
figure out how to make it capture all text that goes to LPT1 and how to
make the printer driver work from the GUI.  In the GUI, I am constantly
getting the PMSPOOL.EXE error SYS3175, and I've looked it up in the
documents "on-line" and in the books as well as on the Internet,
however, I cannot figure out what was wrong.  Does anyone have any idea how
I can make this work or where I can turn for further help?  Thanks for any
help.

Also, as I mentioned, this machine is running on a 386/40 w/ 8Megs RAM. 
Would this machine be able to handle it?  If not, what are the minimum
requirements for Warp 4?  Thanks for any help.

Eric Theriault
FX Bulletin Board Systems
Software Development Incorporated
Voice:  603-882-4880
BBS:    603-882-3859
Fax:    603-882-3859
E-mail: info{at}fxbbs.com 
--- GEcho 1.11+