In a message to All , David Lanes said: 
DL>After learning about the 'upgrades' to QMWIN on this echo, I downloaded
DL>QWIN111B.EXE AND QWIN111C.EXE plus the Help file from the Mustang BBS
DL>and tried to install them today.
DL>There are two principal questions I would very much appreciate receivin
DL>advice on:
DL>FIRST:
DL>Everything seemed to go well but after following all instructions
DL>and installation was completed,  I ran QMWIN and the logo STILL
DL>indicated I was working with v1.11a!!  My QMWIN.EXE  file is dated
DL>10/01/94 and contains 1,590,592 bytes so apparently was not modified.
DL>The 1.11b files are dated 3/29/95 and the 1.11c files are dated 5/25/95
I haven't applied the 1.11c patch yet, but my 1.11b QMWIN.EXE is 1,601,984 
and is dated 2/13/95 and it says 1.11b when I start up...the patch to "b" 
didn't work for you.
DL>Would anyone have any ideas as to why the version number does not read
DL>1.11c??  After I ran QWIN11B.EXE, I got a message that said:
DL>  "If three files were patched your upgrade was successful!"
Did you watch carefully?  The error for the .EXE file may have scrolled by.
DL>That was the case and I do not see why I was not at least "promoted" to
DL>v1.11b.  In the case of QWIN111C.EXE, I did rceive a somewhat
DL>bewildering message when the patch was being run which ran as follows":
DL>"Applying MODIFY File Patch for 'QMWIN.EXE'
DL>"error ept0036: Old File not found. However, a file of the same name wa
DL>                found. No update done since file contents do not match.
DL>                [The name of the "old file" was not identified.]
DL>Can anyone explain what the above means and what I should/can do to get
DL>to v1.11c  - or at least v1.11b [since I don't give a hoot about the
DL>"added support for MD5 secure passwords" ??
It means that the 1.11c patch wasn't successful.  I'd start over with a 
clean v1.11a and apply the "b" patch again...watch carefully for errors!
DL>SECOND
DL>After updating from my original QmodemPro for Windows  to v1.11c
DL>[updates through v1.11a went without a hitch] I seem to have an awful
DL>lot of files that may not be necessary.  Am afraid that Mustang has not
DL>been overly helpful in advising what files may be safely deleted.  I
DL>        QMWIN110.RTP     134,806 bytes     5/7/94
DL>        QMWIN111.RTP     275,006          11/4/94
DL>        QM111B.RTP       398,472          3/29/95
DL>        QWIN111C.RTP      29,831          5/25/95
DL>        PATCH.EXE         54,779          5/25/95
DL>Are all the above needed to run QMWIN??
NONE of the above are needed once the patch process has completed 
SUCCESSFULLY (which is not the case in your situation)...once you get a 
"working V1.11b or 1.11c you can safely delete these
DL>Finally, the QMWIN.HLP file [645,068] is dated 3/28/95 but the
DL>LATENEWS.HLP file [16,105] is dated 10/27/94.  Should we not have
DL>received an update on the changes effected in v1.11b?
The only changes I saw for the "b" version were in a file called QM111B.NEW
Fred  -- hallf@rl.af.mil -- member of the "Win95" 400K Club
... A loaf of bread, a jug of wine and .
 * Wave Rider 1.32 # 81 *
--- GEcho 1.11+
---------------