Hello, I was wondering if anyone was having a problem with ANSI
emulation and the USR 56.6k RapidComm terminal software?  When I first
installed the software, it worked fine, but now when I call my favorite
IBM BBS, I get the ANSI colors ok but the graphics are all characters
instead of lines and graphic characters.  It looks like I am recieving
the graphics, but they are not being translated properly.
  
I am using the default terminal protocol with ANSI emulation.  Maybe
there is a setting I can check to change this so it will work again?
I thought it was because I was using Microsofts Hyperterminal program
(BTW there is an upgrad for this program on the www.microsoft web site
 which enables autoanswer) in 7 bit VT-100 mode before I used RapidComm
and I thought that might screw up the character set, but even when I
use RapidComm 1st I still have the problem.
 
Thanks for any help on this ANSI no-graphics problem!  John :)
--- WILDMAIL!/WC v4.12 
---------------