LB>  >> native OS2 programs?

LB>  VD> Thanks for the reply Leif. The reason I ask, is that I would like to
LB>  VD> write simple textmode os2 progs, however I haven't been successful. I
LB>  VD> use LLIBCE (built for os2 & dos) and the following
compile command: "
LB>  VD> cl  /FPc /W4 /AL /Lp test.c " followed by a simple
" LINK test; "
LB>  VD> command.  If I do this for the code below, the .exe will cause a
LB>  VD> switch to DOS  when I try to run it under os2. Do you have any
LB>  VD> suggestions as to what  I'm doing wrong?

LB> I think you need to bind your program in the last step. I think
LB> BIND TEST.EXE SYSCALL0.LIB DOSCALLS.LIB -o TESTFAM.EXE
LB> should solve your problems

Thanks again for the reply Leif. I solved the problem by building a new 
os2 lib file: LLIBCEp.LIB and explicitly linking it:

 LINK test.obj,,,llibcep
 
which so far is doing the job for the simple programs I have tested.

Regards, Vic Dura (victor.dura{at}woodybbs.com)
Rogersville, AL

---
 * RM 1.3 01752 * FLUSH the incumbents, restore citizen government.

--- QScan v1.131b / 01-0087