-> A while back there was a discussion on check book reconciliation
-> problems.
->
-> Quicken Deluxe Windows v4.0
-> Everything was fine and out of no where there's a $700 dollar
-> "error".
-> Any and all help appreciated.
Well, David, I wasn't reading this echo "a while back" so I don't know
what the earlier discussion covered.  You also haven't given any
specifics as to your problem, so the best I can offer is a few general
tips about reconciling your checkbook.
If Quicken is telling you your register balance doesn't match what is on
the bank statement, there are generally two possible reasons:
1.  There are transactions (checks, deposits, service charges, etc.) on
the bank statement that you haven't entered into your register yet.
2.  You incorrectly entered the amount of one or more transactions into
your register (or, much less likely but still possible, the bank
recorded the amount of some transaction incorrectly in *its* system).
Correcting either of these mistakes basically requires a line-by-line
double check of your bank statement.  Check each line on the statement,
find the corresponding entry in your Quicken register, and check it off
on the statement.  If there is a discrepancy, edit your register.
If these steps don't fix the problem, you'll need to provide additional
detail to get any useful help.
Good luck.
--- PCBoard (R) v15.22/100 (09-01-95 18
---------------