Got a strange problem installing 4.1 under Warp..  I cant get the AHA1540.DSK 
driver to load..  The address is right, 330.. I check'd in the util at bootup 
anyway..
The client stuff went ok, ex for the network error when I boot..  I figured 
if there's no server that would cause it??
The server seems to start, I just cant see the drive..  :{
The drive btw is a Conner 2 gig SCSI, with boot magager install'd, a 200 meg 
FAT partition for OS2, about 1.5 gig HPFS for Warp, & I was gona use the rest 
for Novell..
The message I get is:
Unable to reserve hardware, possible conflict
Module init failed
Module not loaded
I thought I had it install'd once sharing the controller with Warp, but am 
not sure if I had IDE in the machine or not..  Had several test machines I 
was trying OS/2 on befor setting up this new machine for this & running my 
board..
Any ideas??
TIA
Rich
I-Net    turtil@chester.ny.frontiercomm.net
... out numbered 20,000 to 2...... and we killed them both.
--- GEcho 1.00
---------------